Forced Draft
BTEX
Emissions Unit
Forcing Air Past Tube Arrays to Increase Convection in Areas With Stagnant Wind Conditions
Our electric BTEX emission system is made with all stainless steel, ASME stamped heat exchangers, completely manufactured and tested by Spiral X. All BTEX units are equipped with a Spiral X Governance Module to monitor units and maintain compliance. The Forced Draft BTEX system forces air past finned tubes via electric fans to create condensation in all environments. Electric supply capable of 230/480 VAC must be available. Regeneration capability ranges from 200,000 – 3.5MM BTU/hr..
The Benefits
- No PSV Pops
- Convenient Hookup
- Small Footprint
- Consistent Condensate
- Modular Design
- Hail Protection
- Low Installation Cost
- Cold-Weather Enclosure Available
Standard Specs
- Versa Pilot Valves
- Fisher Regulators
- Kimray/Rosemount/Babbitt level controls
- Sharpe Bypass Valve
- Spiral X Governance Module
Governance Module
Keep compliance with the Spiral X Governance Module, an interactive BTEX Unit monitoring system that stores and distributes Modbus information and all I/O data. The Module interface is accessed via an HMI screen, where users can control and monitor real-time data from Spiral X emissions control BTEX systems.